Genuine 5.5" 2560x1440 Light Curing Display for LCD 3D Printers, covered with tempered glass
The screen is a special SHARP screen for EPAX X1 printer ONLY. It has two interfaces. One SX04 hidden in a tape and one SX03 as default interface. Use proper interface for your printers.
Using this screen with any other similar LCD printers is not supported.
The screen has tempered glass installed on top. So even if you spill resin on top of it, you can gently shovel off. Do not leak resin under the screen through edges. Cover edges with 0.1mm thick kapton tape if needed.
LCD screen specification:
Size: 5.5 inch
Pixel precision: 47.25um
Display area: 68.04x120.96mm
Appearance size: 70.94x128.49x1.45mm
Drive board specification:
HDMI to MIPI
USB 5V power supply, supporting 2K resolution
Support PC and raspberry pi
1 * 3D printer lcd screen 5.5 inch
LCD screen is consumable in this printing technology. A lot of failed screens are due to tiny residues in resin and those residues get pushed to screen hard, leading to heated stress spots. We guarantee it works at arrival and installed. No warranty afterwards.
Each LCD screen comes with one pre-cut tape to prevent resins leak into screen. Please check out the installation video described in our pre-cut tape listing.